This is an MCQ-based quiz on Water Supply Engineering.
This includes Kuichling’s formula, Freeman formula, Bustan’s formula, Mineral acids, Free CO₂, and Aluminium sulphate.
Biochemical Oxygen Demand (B.O.D.) of safe drinking water must be
For determining the velocity of flow of underground water, the most commonly used non-empirical formula is
Specific capacity or yield of wells, is generally expressed, as
The yield of a rapid gravity filter as compared to that of slow sand filter, is
If the chosen diameter of a pipe, is less than the economical diameter
Turbidity of raw water is a measure of
The expected discharge to be obtained from an open well sunk in coarse sand is 0.0059 cumec. If the working depression head of the well is 3 m, the minimum diameter of the well, is
What is the most commonly used pump for lifting water in water supply mains?
What does water supply system include?
Percussion drilling is unsuitable in .......
Disinfection of water with ozone is not good because ...........
The efficiency of sedimentation tank does not depend upon
How much is the diameter of pipes in bathrooms and lavatories in the domestic water supply?
What is the economic diameter of the pipe, If the discharge of a pump is 0.16 cumecs?
Air binding is caused due to excessive ........ in a rapid sand filter.
Disinfection of drinking water, is done to remove
Odour
Bacterias
Turbidity
Colour
In distribution pipes, drain valves are provided at
Lower point
Higher point
Junction points
Any where
Aeration of water is done to remove
Odour
Colour
Bacterias
Hardness