+1-315-636-4485
+91 98151-74050 
This is an MCQ-based quiz on Design Of Steel Structures.
This includes horizontal shear, vertical load, bottom chord area, top chord area, effective span of bridge, and heaviest axle load of engine.
For the buildings having a low permeability, the internal wind pressure acting normal to the wall and roof surfaces is taken as (where p is basic wind pressure)
The sway bracing is designed to transfer
The internal pressure coefficient on walls for buildings with large permeability is taken as
The relation between intensity of wind pressure p and velocity of wind V is taken as
If the 20 mm rivets are used in lacing bars, then the minimum width of lacing bar should be
Rivets connecting flange angles to cover plates in a plate girder are subjected to
Hudson’s formula gives the dead weight of a truss bridge as a function of
The number of seismic zones in which the country has been divided are
Maximum pitch of rivets, used in steel stacks, is limited to (where t is thickness of thinner plate being connected)
Which of the following is mainly an alloy of steel?
What is the effect of increased content of Sulphur and Phosphorous in Steel?
............ is the property of high carbon steel.
Which of the following method is mainly adopted for the design of steel structures as per IS code?
Which of the following IS code is used for the general construction of steel?
Which of the following is not included in imposed load classification
The horizontal beams spanning between the wall columns supporting a wall covering are called ........... in factory buildings.
Bulb angles are used in .............
What is the most commonly used sections in the lateral system to carry shear forces in built-up columns?
What is the method of design of steel framework for the greatest rigidity and economy in weight?
When the axis of load lies in the plane of rivet group, then the rivets are subjected to
Only shear stresses
Only tensile stresses
Both (a) and (b)
None of the above
